Summary of Contents for Comtrend Corporation PG-9172AC
Page 1
**The PG-9172 can be replaced by another G.hn Powerline Adapter. NOTE: The following steps show how to create or add onto a G.hn Powerline Network using a PG-9172AC. (A minimum of two G.hn Powerline Adapters are required to create a proper connection.) ! If this is the first time you are setting up a G.hn Powerline Network please continue to Section B.
Page 2
Ethernet Cable Adding to an Existing G.hn Network Plug the PG-9172AC into the power outlet closest to the location you want to add wireless and/or near an Internet-Enabled Device you would like to directly connect to the adapter. The PLC Indicator should light up.
Page 3
Press the “Config” Button of a PG-9172 in the existing network for 2 seconds. You will see the Security Indicator start flashing GREEN. Within two minutes, press the “PLC Sync” Button on the PG-9172AC for 2 seconds until you see the Security Indicator start flashing GREEN.
PLC Indicator should light up. If the PLC Indicator does not light up, it may indicate the existing G.hn network is secure and you have to pair the PG-9172AC to it in “secure mode.” To do so, press the “Config" Button on the PG-9172 for 2 seconds (Holding for more than 4 seconds will clear the security key and require a re-pairing).