Mounting the Inverter
4. Hang the inverter on the bracket (see Figure 12): Lift the inverter from the sides, or hold it at the top
and bottom of the inverter to lift the unit into place. Do not lift holding the StorEdge Connection
Unit as it may be damaged.
5. Align the two indentations in the inverter enclosure with the two triangular mounting tabs of the
bracket, and lower the inverter until it rests on the bracket evenly.
6. Secure the StorEdge Connection Unit bracket to the wall:
Mark the location of the bracket screw for the StorEdge Connection Unit and drill the hole.
l
Fasten the bracket using a standard bolt.
l
Verify that the bracket is firmly attached to the mounting surface.
l
7. Insert the two supplied screws through the outer heat sink fin on both sides of the inverter and into
the bracket (see Figure 12). Tighten the screws with a torque of 4.0 N*m / 2.9 lb.*ft.
8. Remove the inverter cover: Open the inverter cover's six Allen screws and carefully pull the cover
horizontally before lowering it.
26
Figure 12: Hanging the inverter on the bracket
Figure 13: StorEdge Connection Unit bracket
SolarEdge StorEdge Installation Guide MAN-01-000262-1.2