Slave Zones; Multicast Type - Polycom Group Paging/Push-To-Talk - Algo 8188 Installation/Configuration Manual

ALGO

Slave Zones

Select one or more multicast zones for the 8188 SIP Ceiling Speaker
to monitor. Note that multicast zone priority is based on the zone
definition list order (top to bottom).
Multicast Type – Polycom Group Paging/Push-to-Talk
The 8188 SIP Ceiling Speaker may receive multicast paging
compatible with Polycom "on premise group paging" protocol.
To configure the 8188 as a slave to play Polycom page
announcements, select "Group Page" or "Push-to-Talk". Then enter
the Polycom Zone (IP Address and Port) that matches the
configuration of the Polycom phones and Channels. The "Default
Channel" is the target group in a Polycom paging environment.
The Polycom phone used as page audio source for the 8188 SIP
Ceiling Speaker(s) must be configured to use either the G.711 or
G.722 audio codec. The Polycom phone(s) must also be
configured with the "Compatibility" setting
("ptt.compatibilityMode") disabled in order for this codec setting
to be applied.
Document 90-00068
2017-03-28
Page 31
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8188 SIP Ceiling Speaker
(604) 454-3792
support@algosolutions.com