Number Of Zones; Multicast Type; Zone Selection Mode; Master Single Zone - Algo 8188 Installation/Configuration Manual

ALGO

Number of Zones

Select "basic" zones if configuring nine or fewer multicast zones or
"expanded" to configure up to 50 zones. The expanded zones have
the same behaviour as the basic Slave zones, but are hidden by
default to simplify the interface.

Multicast Type

The 8188 SIP Ceiling Speaker may broadcast multicast paging,
compatible with Polycom "on premise group paging" protocol and
most multicast-enabled phones that use RTP audio packets.
Select "Regular" if solely multicasting to Algo SIP endpoints and/or
multicast-enabled phones.
To multicast page announcements solely to Polycom phones, select
"Polycom Group Page" or "Push-to-Talk". Then, configure the 8188
with "Polycom Zone" (IP Address and Port) and "Polycom Default
Channel". Always ensure that the multicast settings on all Slaves
match those of the Master.
Select "Regular RTP + Polycom Group Page/Push-to-Talk" to
multicast page audio to both Polycom phones, Algo SIP endpoints,
and multicast-enabled phones.

Zone Selection Mode

"Single Zone" always broadcasts on one IP address. In "DTMF
Selectable Zone" mode, the IP address is determined by the zone
selected. The DTMF zone definitions can be found in the "Advanced
Settings > Advanced Multicast" tab. For more information see page
14-15.
Note: DTMF codes for zones 10 and higher start with an "*".

Master Single Zone

IP address for multicast broadcast. If "DTMF Selectable Zone" is
chosen above, this setting will not apply to Paging, since the zone
can now be dynamically selected per call via DTMF. However, the
specified "Master Single Zone" setting is still used for any multicast
events triggered by the Ring, analog input, or the relay input.
Document 90-00068
2017-03-28
Page 28
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8188 SIP Ceiling Speaker
(604) 454-3792
support@algosolutions.com