ALGO
Basic Settings Tab - Features
Ring/Alert Tone
Select WAV file to play when a ring event is detected on the SIP Ring
extension. The WAV file may be played immediately to the speaker
from the web interface for test purposes using the Play, Loop, and
Stop buttons. During multicast, the device will broadcast an audio
stream using the Master's selected ring tone.
Ring/Alert Volume
Set speaker volume for SIP ring event. This setting is an amplifier
gain control and the output level will also depend on the levels
recorded into the source WAV file played from memory. This setting
is only used for local tones, and not when receiving multicast (see
Page Speaker Volume below).
Document 90-00068
2017-03-28
Page 24
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8188 SIP Ceiling Speaker
(604) 454-3792
support@algosolutions.com