Sip Paging: Multiple Speakers (Using Individual Sip Extensions) - Algo 8188 Installation/Configuration Manual

ALGO
To enable multicast monitoring in the other speakers, go to the web
interface for each speaker and again navigate to the Basic Settings
 Multicast tab. This time though, choose multicast mode
"Slave/Receiver". There is no need to select a zone as the speaker
will automatically monitor the "All Call" zone IP address.
The page pre-announce tone is generated from the Master. The
following options are valid for each multicast Slave speaker:
Talkback can only be used for the SIP registered Master speaker.
When paging with talkback enabled, only the area near the Master
speaker is covered for talkback. The microphones in the multicast
Slave speakers are disabled except for ambient noise monitoring.
SIP Paging: Multiple Speakers (Using
Individual SIP extensions)
In some cases it may be desirable for every speaker to have a SIP
extension. Multicast may still be used to page multiple speakers but
each speaker can also be called individually or generate a call when
appropriately configured.
A speaker configured as a SIP Multicast Slave will give its highest
priority to a page using its SIP extension.
Communication Servers with the capability of dialling many SIP
extensions simultaneously for paging may be able to create zones by
calling "page groups" and also page telephone speakers in
conjunction with overhead speakers.
Document 90-00068
2017-03-28
Page 15
 Increase or Decrease Speaker Volume
 Enable Ambient Noise Monitoring (speaker volume adapts to
background noise)
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8188 SIP Ceiling Speaker
(604) 454-3792
support@algosolutions.com