Algo 8186 Installation/Configuration Manual page 8

Important Safety Information
CAUTION
The 8186 Horn Speaker is capable of output levels in excess of 120dB
at 1 meter. Ensure nobody is in close proximity to the horn, especially
during installation and testing of the product.
INSTALLATION
The 8186 Horn Speaker should only be installed by a qualified
electrician. An improperly installed 8186 could fall from the wall or
ceiling and cause serious injury or death.
Local building codes may require one or more additional safety
measures, particularly in earthquake prone regions.
EMERGENCY COMMUNICATION
If used in an emergency communication application, the 8186 Horn
Speaker should be routinely tested. SNMP supervision is recommended
for assurance of proper operation. Contact Algo for other methods of
operational assurance including the use of the integrated microphone
for automated "sound to air" acoustic testing.
WET OR OUTDOOR ENVIRONMENTS
The 8186 Horn Speaker is intended for indoor or outdoor locations and
may be subjected to spray or weather provided the rear wiring cavity
is properly sealed to prevent water ingress.
Gaskets included with the 8186 Horn Speaker may be effective against
water ingress on some, but not all surfaces in which case additional
protective measures must be taken such as a perimeter sealant.
CAT5 or CAT6 connection wiring to an IEEE 802.3af compliant
network PoE switch must not leave the building perimeter
without adequate lightning protection.
Relay input and output connections must not leave the building
perimeter without adequate lightning protection.
Document 90-00079
2016-12-08
Page 8
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8186 SIP Horn Speaker
(604) 454-3792
support@algosolutions.com