Multicast Type - Regular; Slave Zones; Multicast Type - Polycom Group Paging/Push-To-Talk - Algo 8186 Installation/Configuration Manual

Multicast Type - Regular

Select "Regular" if solely multicasting to Algo SIP endpoint(s) and/or
multicast-enabled phone(s) that use RTP audio packets.

Slave Zones

Select one or more multicast zones for the 8186 SIP Horn Speaker to
monitor. Note that multicast zone priority is based on the zone
definition list order (top to bottom).
Multicast Type – Polycom Group Paging/Push-to-Talk
The 8186 SIP Horn Speaker may receive multicast paging compatible
with Polycom "on premise group paging" protocol.
To configure the 8186 as a slave to play Polycom page
announcements, select "Group Page" or "Push-to-Talk". Then enter
the Polycom Zone (IP Address and Port) that matches the
configuration of the Polycom phones and Channels. The "Default
Channel" is the target group in a Polycom paging environment.
The Polycom phone used as page audio source for the 8186 SIP Horn
Speaker(s) must be configured to use either the G.711 or G.722
audio codec. The Polycom phone(s) must also be configured
Document 90-00079
2016-12-08
Page 32
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8186 SIP Horn Speaker
(604) 454-3792
support@algosolutions.com