Network Connection - Algo 8186 Installation/Configuration Manual

1202 Call Button: A pair of wires from the
terminal block on the back of the 8186 SIP Horn
Speaker can connect to the centre pair of the
modular connector at the back of the Call
Button.
1203 Call Switch: A pair of wires can be run from
the back of the device via a screw output
connector to the 8186 SIP Horn Speaker via the
Relay In.

Network Connection

Connect RJ45 jack from PoE network switch or non-PoE network
and 48V 350 mA IEEE 802.3af compliant power injector.
There are two lights on the Ethernet jack:
Green light: On when Ethernet is working, flickers off to indicate
activity on the port.
Amber light: Off when successful 100Mbps link is established.
Typically on only briefly at power up.
Under normal conditions, the Amber light will turn on immediately
after the Ethernet cable is first connected. This indicates that PoE
power has been successfully applied. Once the device connects to the
network, it will switch to the Green light instead, which will typically
flicker indicating traffic on the network.
Document 90-00079
2016-12-08
Page 19
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8186 SIP Horn Speaker
(604) 454-3792
support@algosolutions.com