Table of Contents
Advertisement
Installation & Mounting
The 8186 SIP Horn Speaker can be wall or ceiling mounted.
Concealed wiring may enter from the wall into the wiring cavity.
Alternatively, surface wiring may enter through a channel from the
bottom edge. The channel is intended for cabling 0.2" or 5mm in
diameter and is intentionally snug to protect against moisture
ingress.
The 8186 SIP Horn Speaker can be mounted in any orientation but
both the bracket and housing identify TOP. This keeps the bracket
wiring channel on the bottom and the RJ45 jack on the top side.
The mounting plate may be used to mount over flush or surface
mounted electrical boxes or mud rings and fits securely to a 2 gang
electrical box for installation with wiring conduit.
The 8186 SIP Horn Speaker is rated IP65 for wet locations however
care must be taken to ensure that water does not enter the wiring
cavity. The supplied gaskets or sealant must be used to protect the
wiring cavity in wet environments. In dry indoor environments the
gaskets are not required. If the wall gasket is used with surface
wiring then the gasket should be attached after placing the cable into
the wiring channel.
The 8186 SIP Horn Speaker should not be installed beyond a building
perimeter without adequately protecting the building wiring from
lightning surges.
Document 90-00079
2016-12-08
Page 11
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8186 SIP Horn Speaker
(604) 454-3792
support@algosolutions.com
Hide quick links:
Advertisement
Table of Contents
