Table of Contents
Advertisement
Getting Started - Quick Install & Test
This guide provides important safety information which should be
read thoroughly before permanently installing the speaker.
1. Connect the 8186 SIP Horn Speaker to an IEEE 802.3af compliant
PoE network switch. The blue LED will remain on until boot up is
completed – about 30 seconds.
2. After the blue light turns off, connect the reset terminals on the
back of the unit to hear the IP address over the speaker. The IP
address may also be discovered by downloading the Algo locator tool
to find Algo devices on your network:
3. Mount the speaker per the instructions in this guide.
4. Access the 8186 SIP Horn Speaker web page by entering the IP
address into a browser (Chrome, IE, Firefox etc.) and login using the
default password algo.
5. Enter the IP address for the SIP server into the SIP Domain field
under the BASIC SETTINGS > SIP tab.
6. Enter the page SIP extension and password. (Note the speaker
supports two types of SIP extensions. The page extension auto-
answers for voice page announcements. The ring extension plays an
audio WAV file over the speaker without answering.)
7. Make a call to the speaker by dialling the page SIP extension from a
telephone. The speaker should auto-answer, play the default pre-
announce audio file, and open a speech path.
Document 90-00079
2016-12-08
Page 10
Algo Communication Products Ltd
4500 Beedie St Burnaby BC Canada V5J 5L2
www.algosolutions.com
8186 SIP Horn Speaker
www.algosolutions.com/locator
support@algosolutions.com
(604) 454-3792
Hide quick links:
Advertisement
Table of Contents
