Solid-state drive
Description
256-GB SATA-3 self-encrypting SSD
180-GB SATA-3 SSD
128-GB SATA-3 SSD
128-GB mSATA-3 SSD for use in Brazil
32-GB mSATA flash cache SSD
Before removing the solid-state drive, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
5.
Remove the service cover (see
Remove the solid-state drive:
1.
Remove the two Phillips screws (1) that secure the solid-state drive to the system board. (The solid-
state drive tilts up.)
2.
Remove the solid-state drive (2) by pulling the drive away from the slot at an angle.
Reverse this procedure to install the solid-state drive.
Battery on page
64).
Service cover on page
65).
Component replacement procedures
Spare part number
749263-001
749262-001
749278-001
749261-001
749277-001
749280-001
749281-001
79