Audio Jack Module; Power Connector Cable - HP ENVY x360 Maintenance And Service Manual

Audio jack module

Description
Audio jack module (includes cable)
Before removing the power connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
a. Battery (see
b. Fan (see
c. System board (see
d. Display assembly (see
Remove the audio jack module:
1. Remove the Phillips PM2.0×2.3 broad head screw (1) that secures the audio jack module to
the keyboard/top cover.
2. Lift front edge of the audio jack module (2) until it rests at an angle.
3. Remove the audio jack module (3) by sliding it up and to the right at an angle.
Reverse this procedure to install the audio jack module.
Bottom cover on page
Battery on page 22)
Fan on page 30)
System board on page
Display assembly on page
20), and then remove the following components:
31)
34)
Component replacement procedures
Spare part number
801497-011
37