Reverse this procedure to install the heat sink.
Display assembly
Description
13.3-in, UHD (3840×2160), WLED, BrightView, ultraslim-flat (2.00-mm), UWVA, (eDP 1.3+PSR),
TouchScreen display assembly with flush glass design, 72% color gamut; typical brightness: 340 nits;
16:9 ultra wide aspect ratio; equipped with an FHD webcam/microphone module
13.3-in, QHD+ (3200×1800), WLED, BrightView ultraslim-flat (2.60-mm), UWVA, (eDP 1.2), TouchScreen
display assembly with flush glass design, 72% color gamut; typical brightness: 300 nits; 16:9 ultra wide
aspect ratio; equipped with an FHD webcam/microphone module
13.3-in, UHD (3840×2160), WLED, BrightView, ultraslim-flat (2.00-mm), UWVA, (eDP 1.3+PSR),
TouchScreen display assembly with flush glass design, 72% color gamut; typical brightness: 340 nits;
16:9 ultra wide aspect ratio; equipped with an HD webcam/microphone module
13.3-in, QHD+ (3200×1800), WLED, BrightView ultraslim-flat (2.60-mm), UWVA, (eDP 1.2), TouchScreen
display assembly with flush glass design, 72% color gamut; typical brightness: 300 nits; 16:9 ultra wide
aspect ratio; equipped with an HD webcam/microphone module
Before removing the display assembly, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
34
Chapter 5 Removal and replacement procedures
Bottom cover on page
20), and then remove the following components:
Spare part number
906707-001
906706-001
914609-001
914608-001