Touchpad - HP ENVY x360 Maintenance And Service Manual

TouchPad

Description
TouchPad (includes cable)
Before removing the TouchPad, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the TouchPad:
1. Release the zero insertion force (ZIF) connector (1) to which the TouchPad cable is connected, and then
disconnect the TouchPad cable from the system board.
2. Detach the TouchPad cable (2) from the keyboard/top cover. (The TouchPad cable is secured to
the keyboard/top cover with double-sided adhesive.)
3. Remove the five Phillips PM2.0×2.3 broad head screws (3) that secure the TouchPad to the keyboard/
top cover.
4. Remove the TouchPad (4).
Reverse this procedure to install the TouchPad.
Bottom cover on page
Battery on page 22).
20).
Component replacement procedures
Spare part number
906721-001
27