Wlan Module - HP ENVY x360 Maintenance And Service Manual

5. Remove the battery (2).
Reverse this procedure to install the battery.

WLAN module

Description
Intel Dual Band Wireless-AC 7265 802.11 AC 2×2 Wi-Fi + Bluetooth 4.2 Combo Adapter
CAUTION: To prevent an unresponsive system, replace the wireless module only with a wireless module
authorized for use in the computer by the governmental agency that regulates wireless devices in your
country or region. If you replace the module and then receive a warning message, remove the module to
restore device functionality, and then contact technical support.
Before removing the WLAN module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the WLAN module:
1. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
The WLAN antenna cable labeled "2/AUX" connects to the WLAN module "Aux" terminal.
2. Remove the Phillips PM2.0×2.8 screw (2) that secures the WLAN module to the computer. (The WLAN
module tilts up.)
Bottom cover on page
The WLAN antenna cable labeled "1/MAIN" connects to the WLAN module "Main" terminal.
20).
Battery on page 22).
Component replacement procedures
Spare part number
793840-005
23