~
W-ING:
CONNEC~RBLOCK IS
– MPROWD FORCOPPER Wm
~coNNEmoN ONLY*
2*
Nwinum
Wifing
b
L Connect length of copper building wire to
range terminal block.
~. splice copperwiresto aluminum wiringusing
specialconnectorsdesignedandU.L.approvedfor
joiningcopperto aluminum, a ndfollow the
connectormanufacturer's r ecommended
procedureclosely.
NOTE: Wire used, location and enclosure of
splices, etc., must conform to good wiring practice
and local codes.
SEP
5
HIRE SYSTEM
SPECW @RouNDIMG
iMsFRucTloHs
w~G:
Framegroundedto neutralofappfiance througha
link.Hused in
a MOBILE HOME or if LOCK
CODES do not permit grounding through the
neutral:
1) disconnect the link from neutral,
2) use grounding terminal or lead to ground unit in
accordance with local codes, and
A
~) connect neutral terminal or lead to branch
~~Luui~in
usualmanner.
(Ifthe applianceis to be connectedby meansofa
cordset, use 4-conductor c ordforthis purpose.)
CONNECTOR
BLOCK
4TH GROUNDING
LEAD
~~
>
GROUND
LUG
STEP 6
AHT!"T!P BMCKET
iHsfhLLATfloM
~ ~~-TIP bracketis suppliedwithinstructions
forinstallationin a varietyoflocations. T he
instructionsincludea template,a Parts list and a
list
of tools necessary to c~mplet~the installation.
Read the
lMPORT'~T SN~
1NSTRUCTIONS
L andthe instructionsthat fitvoursituationbefore
z~eg-ififiiugs
installation.
"
WABNSHG
1. Rangemustbe securedby
ANTI-TIP
bracket
supplied.
2.
See
instructionsto install(supplied with
bracket).
~. Unlessproperlyinstalled,rangecouldbe tipped
by steppingor sittingon door.Injurymightresult
fromspilledhot liquidsor fromrangeitself.
Typical installationof Anti-Tip bracket
Attachmentto Wall
Bracket
ScrewMust Enter
Wall plate
Wood or Metal
h
STEP 7
LEVEL[MG TME MNGE
The rangemustbe leveled.Leveling feet zYe
locatedon eachcorner ofthe base ofthe range.
~emovethe storagedrawerand rotatethe leveling
feetin or outas required.To removedrawer,pullit
outallthe way,tiltup the frontandremoveit.To
replace,insert glidesat back ofdrawerbeyond
stopon rangeglides.Li drawerifnecessaryto
insert easily.
Oneofthe rear levelingfeetwillengagethe ~T1-
TIP
bracket (allow for somesideto side
adjustment). A llowa minimumclearanceof 1/811
betweenthe range and the levelingfootthat is to
be installedintothe ~T1-TIP bracket.
Checkthe rangefor properinstallation intothe
ANTI-TIPbracket (after the range has been
properly installed) by grasping the edges of the
~AR burner holes and carefully attempting to tilt
the range forward.
STEP8
FINALCHECK
Be sure all switches are in the "off"position before
leaving the range.
29