Advertisement
STEP 2
PREmRE FOR ELEcTR!aL
COWHECTBON
Use only a 3-conductor,or if required a 4
conductor range cord set as noted below.
These cord sets are provided with ring
type terminals.
The electrical rating of the cord must be
125/250 volts minimum, 40 amperes.
NOTE: Only a 4-conductorcord is to be used
when the appliance is instaUed
in a mobile
borne or where local codes do not permit
grounding through the neutral.
STEP3
1. bcate connector block at the bottom rear
of range and remove rear wiring cover.
2. Directly below the connector block is a
hole with a knockout ring for accommodating
conduit fittings. Brackets provided are used to
support the flexible cord strain relief, which
must be securely a~ched to the cord set.
R
3wiRE
SYSTEM
Power COrd lnshflation-Insert
screws
through power cord terminals so that the
{
screws pass through connectorblockterminals
and engage nuts. Tighten screws securely.
;EW+
?
POWER CORD
...
RING TERMINAL
k
@\~
<>.!
:~:::CTOR
/
e
MOVABLE
TERMINAL
NUT
i
CableDhect
lnstiation-Clamp
bare wires
between the connector block terminals and
movablenuts with screws tightened securely.
..
9
b
+
SCREW
*
.
!
@
::JJ:cTOR
BARE
TERMINAL
WIRE~
'
Q-
FLEXIBLE
CABLE
MOVABLE
NUT ~
.
1.
copper
Wtig
Connect the neutral or grounded wire of the
supply circuit to the neutral terminal of the
connector block, located in the center. The
power leads must be connected to the outside
(brass colored) terminals.
GROUNDING STRAP
(GROUNDED TO RANGE)
Advertisement
