Heat Sink - HP 242 G1 Maintenance And Service Manual

h. Fan (see
i. System board (see
Remove the power connector cable:
1. Turn the system board upside down, with the front toward you.
2. Disconnect the power cable from the system board.
Reverse this procedure to install the power connector cable.

Heat sink

Description
Heat sink for use in models with discrete graphics (includes replacement thermal material)
Heat sink for use in models with UMA graphics (includes replacement thermal material)
Before removing the heat sink, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Hard drive (see
b. WLAN module (see
c. Solid-state drive (see
Fan on page 57)
System board on page
Battery on page
Hard drive on page
WLAN module on page
mSATA drive on page
61)
33) and then remove the following components:
34)
37)
39)
Component replacement procedures
Spare part number
718431-001
728409-001
65