Power Connector Cable - HP 242 G1 Maintenance And Service Manual

12. Remove the system board by sliding it up and to the right an angle (2).
Reverse this procedure to install the system board.

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Hard drive (see
b. WLAN module (see
c. Solid-state drive (see
d. Memory module service cover (see
e. Optical drive (see
f. Keyboard (see
g. Top cover (see
64 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 33) and then remove the following components:
Hard drive on page 34)
WLAN module on page
mSATA drive on page
Memory module on page
Optical drive on page
Keyboard on page 47)
Top cover on page 50)
37)
39)
40)
42)
Spare part number
732625-001