HP 242 G1 Maintenance And Service Manual page 72

7. Release the ZIF connector (2) to which the audio/USB board cable is attached, and then
disconnect the audio/USB board cable from the system board.
8. Release the power connector (1) from the clips and molding built into the base enclosure.
9. Release the power connector cable (2) from the routing channel built into the base enclosure.
10. Remove the three Phillips PM2.5×4.5 screws (3) that secure the system board to the base
enclosure.
11. Lift the right side of the system board (1) until it rests at an angle.
Component replacement procedures 63