HP 242 G1 Maintenance And Service Manual page 50

2. Lift the rear edge of the memory module service cover (2) and swing it up and forward until it
disengages from the computer.
3. Remove the memory module service cover.
The memory module service cover is included in the Plastics Kit, spare part number
728283-001.
4. Spread the retaining tabs (1) on each side of the memory module slot to release the memory
module. (The memory module tilts up.)
5. Remove the memory module (2) by pulling the module away from the slot at an angle.
Reverse this procedure to install a memory module.
Component replacement procedures 41