Display Assembly - HP chromebook 13 g1 Maintenance And Service Manual

Display assembly

Description
Bezel
Panel (FHD)
Panel (QHD+)
Hinge kit (includes left and right hinges and caps)
Cable (LVDS QHD+)
HD camera/microphone module
Display enclosure (includes antennas, rubber padding, and shielding)
IMPORTANT:
and replacement.
Before removing the display assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the two computer feet and base enclosure (see
5. Remove the battery (see
6. Remove the heat sink (see
7. Remove the WLAN module (see
8. Remove the system board (see
9. Remove the speakers (see
10. Remove the SD card reader board (see
Remove the display assembly:
1. Remove the two screws from the right hinge and the two screws from the left hinge (1), and then
remove the display assembly (2).
Make special note of each screw and screw lock size and location during removal
Battery on page
Heat sink on page
WLAN module on page
System board on page
Speakers on page
Computer feet and base enclosure on page
21).
21).
23).
25).
27).
SD card reader board on page
Spare part number
859529–001
859533–001
859534-001
859530-001
861672-001
861692-001
859532-001
28).
Component replacement procedures
19).
31