Touchpad Board - HP chromebook 13 g1 Maintenance And Service Manual

TouchPad board

Description
TouchPad board (includes brackets)
Before removing the TouchPad board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the two computer feet and base enclosure (see
5. Remove the battery (see
6. Remove the heat sink (see
Remove the TouchPad board:
1. Disconnect the TouchPad board cable (1).
2. Remove the three Phillips screws (2) that secure the TouchPad bracket to the TouchPad and remove the
TouchPad bracket (3).
3. Remove the three Phillips screws (4) that secure the TouchPad to the keyboard/top cover.
4. Remove the TouchPad board (5).
Reverse this procedure to install the TouchPad board.
Battery on page 21).
Heat sink on page 21).
Computer feet and base enclosure on page
Component replacement procedures
Spare part number
861674-001
19).
29