Sd Card Reader Board - HP chromebook 13 g1 Maintenance And Service Manual

SD card reader board

Description
SD card reader board
Before removing the SD card reader board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the two computer feet and base enclosure (see
5. Remove the battery (see
6. Remove the heat sink (see
7. Remove the WLAN module (see
Remove the SD card reader board:
1. Release the connector (1) to which the SD card reader board cable is attached, and then disconnect
the SD card reader board cable from the system board.
2. Remove the Phillips screw (2) that secures the SD card reader board to the base enclosure.
3. Remove the SD card reader board (3).
Reverse this procedure to install the SD card reader board.
28 Chapter 5 Removal and replacement procedures
Battery on page 21).
Heat sink on page 21).
WLAN module on page
Computer feet and base enclosure on page
23).
Spare part number
859524-001
19).