Connect To An Existing Wifi Network; Place The Extender And Apply Power; Use The Extender In Extender Mode - NETGEAR EX6120 Quick Start Manual

Use the Extender in Extender Mode

Place the extender, apply power, and connect it to your WiFi network.

Place the Extender and Apply Power

1. Place your extender in the same room as your WiFi router.
Proximity to the WiFi router is required only during the initial setup
process.
2. Plug the extender into an electrical outlet and wait for the Power LED
to light green.
If the Power LED does not light, press the Power On/Off button on
the extender.

Connect to an Existing WiFi Network

To extend the range of your WiFi network, you must connect the extender
to your existing WiFi network. You can do this in one of two ways:
• Connect with WPS. For more information, see
.
page 6
• Connect with web browser setup. For more information, see
Connect with Web Browser Setup .
on page 9
5
Connect with WPS
on