Connect To An Existing Wifi Network - NETGEAR EX7300 Nighthawk X4 AC2200 Quick Start Manual

Connect to an Existing WiFi Network

To extend the range of your WiFi network, you must connect the extender
to your existing WiFi network. You can do this in one of two ways:
• Connect with WPS. For more information, see the following section
• Connect with the NETGEAR installation assistant. For more
information, see
.
page 9
Connect With WPS
Wi-Fi Protected Setup (WPS) lets you join a secure WiFi network without
selecting the network name and entering the password.
Note: WPS does not support WEP network security. If you are using WEP
security, follow the instructions in
Assistant
on page 9
1. Press the WPS button on the extender.
The WPS LED
2. Within two minutes, press the WPS button on your router or access
point.
The WPS LED on the extender lights solid green, the Router Link LED
lights, and the extender connects to your existing WiFi network.
If the Router Link LED does not light, try again. If it still does not light,
see Connect With the NETGEAR Installation Assistant
Connect With the NETGEAR Installation Assistant
.
blinks.
Connect With the NETGEAR Installation
6
.
on
.
on page 9