Use The Extender In Extender Mode - NETGEAR EX7300 Nighthawk X4 AC2200 Quick Start Manual

Use the Extender in Extender Mode

In extender mode, the extender repeats the signals from an existing WiFi
router or access point.
Set the Access Point/Extender switch, place the extender, supply
power, and connect it to your WiFi network.
Set the Access Point/Extender Switch
To use the extender in extender mode, set the Access Point/Extender
switch to Extender
Place the Extender and Supply Power
1. Place your extender in the same room as your WiFi router.
Proximity to the WiFi router is required only during the initial setup
process.
2. Plug the extender into an electrical outlet.
Wait for the Power LED
100 seconds. If the Power LED does not light, press the Power On/
Off button on the side of the extender.
.
to light green. This might take up to
5