Power Connector - HP Compaq Presario CQ61 Maintenance And Service Manual

Power connector

Description
Power connector (includes cable)
Before removing the power connector and cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on,
and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Wireless module compartment cover (see
b. Hard drive cover (see
c. Optical drive (see
d. Keyboard (see
e. Keyboard cover (see
f. Display assembly (see
g. Top cover (see
Remove the power connector:
1. Disconnect the power connector cable 1 from the system board and remove the cable from its routing channel.
2. Release the power connector 2 from its mounting clip.
Reverse this procedure to install the power connector.
Maintenance and Service Guide
Downloaded from LpManual.com Manuals
"Battery" on page 4-7).
"Hard drive" on page
"Optical drive" on page
"Keyboard" on page 4-16).
"Keyboard cover" on page
"Display assembly" on page
"Top cover" on page 4-29).
"WLAN module" on page
4-10). HP recommends removing the hard drive.
4-15), recommended.
4-18).
4-21).
Removal and replacement procedures
Spare part number
533465-001
4-8).
4–35