HP Compaq Presario CQ61 Maintenance And Service Manual page 59

Removal and replacement procedures
Remove the display assembly:
1. Open the computer as far as possible.
2. Disconnect the display panel/webcam cable 1 from the system board and remove the cable from the cavity
between the system board and the left display hinge.
3. Disconnect the microphone cable 2 from the system board and remove the cable from the clips and routing
channels 3 built into the top cover.
4. Remove the WLAN antenna cables 4 from the clips and routing channels built into the top cover.
CAUTION: Support the display assembly when removing the following screws. Failure to support the display
Ä
assembly can result in damage to the display assembly and other computer components.
5. Remove the four Phillips PM2.5×6.5 screws 1 that secure the display assembly to the base enclosure.
6. Lift the display assembly 2 straight up.
4–22
Downloaded from LpManual.com Manuals
Maintenance and Service Guide