Display Assembly - HP ENVY Maintenance And Service Manual

Reverse this procedure to install the RTC battery.

Display assembly

NOTE: The display assembly is spared at the subcomponent level only. For more display assembly spare
part information, see the individual removal subsections.
Before removing the display assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
a. Battery (see
b. Solid-state drive (see
c. WLAN module (see
d. Power connector bracket (see
e. Fans (see
f. System board (see
Remove the display assembly:
1. Remove the three Phillips PM2.5×4.4 screws (1) that secure the display assembly to the keyboard/
top cover.
46 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 28)
Solid-state drive on page
WLAN module on page
Power connector cable on page
Fan on page 37)
System board on page
26), and then remove the following components:
29)
31)
36)
39)