Fan - HP ENVY Maintenance And Service Manual

5. Remove the power connector cable (5).
Reverse this procedure to install the power connector cable.

Fan

Description
Fans (2, include cable)
Before removing the fans, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Disconnect the battery cable from the system board (see
Remove the fans:
1. Disconnect the fan cables (1) from the system board.
2. Release the display panel cable from the routing clips built into the left fan (2).
3. Release the wireless antenna cable from the routing clips built into the right fan (3).
4. Remove the two Phillips PM2.5×4.4 screws (4) that secure the fans to the keyboard/top cover.
Bottom cover on page 26).
Spare part number
829296-001
Battery on page 28).
Component replacement procedures 37