Fingerprint Reader Board - HP ENVY Maintenance And Service Manual

Fingerprint reader board

Description
Fingerprint reader board
NOTE: The fingerprint board spare part kit does not include the fingerprint reader board bracket or the
fingerprint reader board cable. The fingerprint reader board bracket is available using spare part number
829302-001. The fingerprint reader board cable is available using spare part number 829295-001.
Before removing the fingerprint reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the fingerprint reader board:
1. Release the zero insertion force (ZIF) connector (1) to which the fingerprint reader board cable is
attached, and then disconnect the fingerprint reader board cable from the system board.
2. Detach the fingerprint reader board cable (2) from the keyboard/top cover. (The fingerprint reader board
cable is attached to the keyboard/top cover with double-sided adhesive.)
3. Remove the two Phillips PM2.0×2.5 screws (3) that secure the fingerprint reader board and fingerprint
reader board bracket to the keyboard/top cover.
4. Remove the fingerprint reader board bracket (4).
34 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 28).
26).
Spare part number
836257-001