Table of Contents
Advertisement
Connector board
NOTE:
The connector board spare part kit includes a cable and double-sided adhesive.
Description
For use only on computer models equipped with WWAN capability (includes SD Card Reader slot and SIM
slot) for use on HP Chromebook 14 PC, and for use on HP Chromebook 14 G3
For use only on computer models not equipped with WWAN capability (includes SD Card Reader slot) for
use on all computer models
Before removing the connector board, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the keyboard/top cover (see
Remove the connector board:
1.
Release the ZIF connector (1) to which the connector board ribbon cable is attached, and then
disconnect the connector board ribbon cable from the system board.
2.
Detach the connector board cable (2) from the battery. (The connector board cable is attached to the
battery with double-sided adhesive.)
3.
Remove the two Philllips PM1.9×2.4 broad head screws (3) that secure the connector board to the
base enclosure.
Keyboard/top cover on page
Spare part number
787715-001
787714-001
25).
Component replacement procedures
33
Advertisement
Table of Contents
