Fingerprint Reader Module - HP 355 G2 Maintenance And Service Manual

Fingerprint reader module

Description
Fingerprint reader module (includes cable and double-sided adhesive)
Before removing the fingerprint reader module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4. Remove the Battery (see
a. Service cover (see
b. Hard drive (see
c. Optical drive (see
d.
Keyboard (see
e.
Top cover (see
Remove the fingerprint reader module:
1.
Turn the top cover upside down with the front toward you.
2. Release the ground tape (1) that secures the fingerprint reader module to the top cover.
3. Detach the fingerprint reader module cable (2) from the top cover. (The fingerprint reader module
cable is attached to the top cover with double-sided adhesive.)
Battery on page 52), and then remove the following components:
Service cover on page
Hard drive on page 54)
Optical drive on page
Keyboard on page 64)
Top cover on page 67)
53)
62)
Component replacement procedures
Spare part number
758062-001
71