Table of Contents
Advertisement
Power connector cable
Description
Power connector cable
Before removing the power connector cable, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the keyboard/top cover (see
5.
Disconnect the battery cable from the system board (see
Remove the power connector cable:
1.
Disconnect the cable (1) from the system board.
2.
Release the cable from the routing clips (2) built into the base enclosure.
3.
Remove the power connector cable (3).
Reverse this procedure to install the power connector cable.
Keyboard/top cover on page
Battery on page
Spare part number
841638-001
23).
42).
Component replacement procedures
29
Hide quick links:
Advertisement
Table of Contents
