HP 17-x Series Maintenance And Service Manual page 73

● Fan/heat sink assembly (see
Solid-state drive (if installed) (see
●
To remove the system board:
1. Position the computer upright, and then disconnect the following cables from the system board:
(1): Keyboard cable
(2): Keyboard backlight cable
(3): Optical drive connector cable
(4): USB board cable
(5): TouchPad cable
(6): Power connector cable
(7): Display cable
(8): Power button board
(9): Speaker cable
2. Remove the Phillips PM2.0×3.0 screw (1) that secures the system board to the computer.
3. Remove the eight Phillips PM2.5×7.0 screws (2) that secure the system board to the computer.
Fan/heat sink assembly on page
Solid-state drive on page
56)
49)
Component replacement procedures 65