3.
If you have a model with UMA graphics and a fan integrated in the heat sink:
a.
Disconnect the fan cable from the system board (1).
b.
In the order indicated, remove the four Phillips PM2.0×3.0 screws (2) that secure the heat sink to
the system board.
c.
Remove the heat sink (3) from the system board.
4.
If you have a model with UMA graphics and no fan integrated in the heat sink:
a.
In the order indicated, remove the four Phillips PM2.0×3.0 screws (1) that secure the heat sink to
the system board.
58
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts