TouchPad click board
Description
TouchPad click board
TouchPad click board cable
TouchPad cable
Before removing the TouchPad click board, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the optical drive (see
6.
Remove the bottom cover (see
To remove the TouchPad click board:
1.
Disconnect the cables from the TouchPad cable (1) and the TouchPad click board cable (2).
2.
Remove the two Phillips PM2.0×4.0 screws (3) that secure the TouchPad to the computer.
3.
Remove the board (4).
Reverse this procedure to install the TouchPad click board.
Battery on page
32).
Optical drive on page
Bottom cover on page
33).
39).
Component replacement procedures
Spare part number
858259-001
856606-001
856605-001
53