Solid-State Drive - HP 17-x Series Maintenance And Service Manual

Solid-state drive

Description
256-GB solid-state drive
128-GB solid-state drive
Before removing the solid-state drive, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Remove the battery (see
4. Remove the optical drive (see
5. Remove the bottom cover (see
Remove the solid-state drive:
1. Remove the Phillips PM2.0×2.0 screw (1) that secures the drive to the system board.
2. Remove the drive (2) by pulling it away from the connector.
NOTE:
Reverse this procedure to install the solid-state drive.
Battery on page
Optical drive on page
Bottom cover on page
Solid-state drives are designed with notches to prevent incorrect insertion.
32).
33).
39).
Component replacement procedures
Spare part number
865902-003
827560-025
49