Power Button Board - HP 17-P series Maintenance And Service Manual

Power button board

Description
Power button board (includes cable)
Before removing the Power button board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the top cover from the base enclosure (see
7. Remove the WLAN module (see
8. Remove the system board (see
Remove the Power button board and cable:
1. Turn the top cover upside down, with the back edge toward you.
2. Remove the 2 Phillips screws securing the Power button board to the base enclosure (1).
3. Remove the Power button board (2).
NOTE:
Reverse this procedure to install the Power button board.
60 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page
Optical drive on page
WLAN module on page
System board on page
The Power button board's cable is attached to the base enclosure.
26),
27).
Base enclosure on page
42).
50).
Spare part number
812177-001
30).