Power Connector; Optical Drive Cable - HP 17-P series Maintenance And Service Manual

6. Remove the top cover from the base enclosure (see
7. Remove the WLAN module (see
8. Remove the system board (see
Remove the RTC battery:
1. Turn the system board upside down.
2. Use a thin, non-conductive tool to remove the RTC battery (1) from the socket on the system board.
Reverse this procedure to install the RTC battery on computer models. When installing the RTC battery, make
sure the "+" sign faces up.

Power connector

Description
Power connector
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the top cover from the base enclosure (see
7. Remove the WLAN module (see
8. Remove the system board (see
56 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
WLAN module on page
System board on page
Battery on page 26),
Optical drive on page
WLAN module on page
System board on page
Base enclosure on page 30).
42).
50).
27).
Base enclosure on page 30).
42).
50).
Spare part number
763699-001