TP-Link RE590T Quick Installation Manual

Quick Installation Guide
Hello, RE590T
Start Here >>
4 Relocate
Place the extender halfway between your wireless router (Host Network) and the Wi-Fi dead zone.
1
Host Network
Make sure the extender receives a strong signal (recommended signal strength
2
not, relocate it closer to the router.
Note: Make sure to place the extender away from all Bluetooth devices and other household electronics.
1 Install
Install the antennas and position
them vertically.
2 Power on
Plug the extender's adapter into an electrical outlet near
your router. Then turn on the extender and wait until the
system boot on the screen completes.
Extended Network
Ideal Extender Placement
or ) from your wireless router. If
3 Configure
Create a new administrator password (recommended) and tap Save.
1
Select your router's 2.4GHz wireless network and enter its password, and
2
then tap Next.
Select your router's 5GHz wireless network and enter its password, and
3
then tap Next.
Note: If your router does not support the 5GHz band, tap Skip.
Either keep the default SSIDs or customize them for both 2.4GHz and
4
5GHz extended networks, and then tap Next.
Note: Please swipe up for the 5GHz settings.
Verify your wireless settings and tap Finish. Corresponding Wi-Fi signal
5
icon(s) ( 2.4GHz/ 5GHz) at the top left of the touch screen should
be lit.
Enjoy!
Connect your devices to the extender wirelessly or via an Ethernet cable.
Wireless RE590T
Note:
1. Both extended networks share the same Wi-Fi password as your host network, but may have
di erent wireless network names if you customize the names during the con guration.
2. To con gure the extender using a web browser or WPS, please refer to FAQ > Q1.
Wired