WARNING 13. Do not use with a damaged cable or plug. If the supply cable is damaged it must be replaced by Dyson, its These warnings apply to the appliance, and also where service agent or similarly qualified person in order to applicable, to all tools, accessories, chargers or mains avoid a hazard.
22. Unplug when not in use for extended periods and before filling, cleaning, maintenance or servicing. INSTRUCTIONS 23. When refilling, only do so as described in this Dyson operating manual. Do not use hot water. THIS DYSON APPLIANCE IS INTENDED 24.
Dyson appliance. 3 Easy ways to register your free Your Dyson appliance will be covered for parts and labour for 2 years from the date of purchase, as detailed in the terms of the 2 year guarantee Dyson guarantee in this Dyson Operating Manual.
Getting started For the best performance place humidifier on the floor in the corner of the room, facing into the centre. It should be at least 1m from any wall. To avoid a cooling effect while humidifying, the unit should be at least 1m from any people.
Page 7
Plug into the socket and base. A small Switch ‘ON’. The water treatment After 3 minutes the appliance will start blue LED on the back of the appliance procedure automatically starts. to humidify. The display will show the lights up to confirm that the appliance Water passes over a UV-C emitter to target humidity setting.
How to use Fan/ humidity toggle ON/ OFF switches between humidifier and fan modes. Control with airflow and timer buttons. On/off Controlling the humidity manually Airflow Increase airflow. Increase target humidity. 1 to 10 30 to 70% Decrease airflow. Decrease target humidity. 10 to 1 70 to 30% The appliance will not mist...
Blue light indicates that the AM10 is in humidity mode. White light indicates that Switch ‘ON’: the water treatment procedure starts. the AM10 is in fan mode. After 3 minutes the appliance will start to humidify.
Cleaning – important! Cleaning procedures must be routinely followed to ensure that the humidifier continues to operate efficiently. Cleaning regimes are designed to help prevent the build up of scale within the machine, which will be more prominent in hard water areas. Failure to adhere to the cleaning regimes may invalidate the warranty.
Once a week Wipe over air loop amplifier, paying close Turn the appliance into standby mode/‘OFF’. attention to the air gaps. Wipe with a Unplug from the mains electricity supply. lint-free microfibre cloth. Empty the water. Rinse and wipe over all surfaces. Repeat if necessary.
Page 12
Once a month (and before/after storage) Turn the appliance into standby mode/‘OFF’. Unclip the loop amplifier surround: pull from Unplug from the mains electricity supply. the lower edge by hand, gently but firmly. 15 mins Empty the water tank. To release the water chimney, twist the dial a quarter of a turn.
Page 13
Cleaning procedures must be routinely followed to ensure that the humidifier continues to operate efficiently. Cleaning regimes are designed to help prevent the build up of scale within the machine, which will be more prominent in hard water areas. Failure to adhere to the cleaning regimes may invalidate the warranty.
What do the lights mean? Water treatment The AM10 is treating the water. This takes 3 minutes. When the animation stops, the AM10 will start to humidify. Tank is empty Switch ‘OFF’ and refill. Tilted The base is not level.
Using your humidifier Please read the ‘Important Safety Instructions’ in this Dyson Operating that level. The fan will remain running when the target humidity Manual before proceeding. has been reached. Introduction Manual mode • Select the desired humidity level (from 30% to 70%). When the •...
To help us ensure you receive prompt and efficient service, please appliance will operate when it is above 5°C (41°F). If other failure register as a Dyson appliance owner. There are three ways to do this: messages are displayed, contact the Dyson Helpline.
Privacy Act Dyson Appliances Ltd (Dyson) may collect and use your personal information to provide you updates on latest products and services, to analyse and research customer’s choice on products, to provide products and services you have requested and for other purposes relating or incidental to product guarantee (e.g.