2.
Lift the display from the computer (4).
If it is necessary to replace any of the display assembly subcomponents:
1.
To remove the display bezel:
a.
Remove the two screw covers (1) and two Phillips PM2.5×4.0 screws (2) that secure the display
bezel to the enclosure.
NOTE:
The following image shows the display panel connected to the computer. It will not be
connected in this procedure.
b.
Flex the inside of the top edge (1), the left and right edges(2), and the bottom edge (3) until the
bezel disengages from the display enclosure.
Component replacement procedures
59