Immergas SUPER CAR Instruction And Warning Book page 7

Fig. 2
NO
Fig. 3
2) Install the Super CAR directly on the wall using the holes
drilled at the back of it (Fig. 1) or in a recessed box using
the screws supplied with it.
3) Do not do the wiring when the boiler powered (Fig. 4).
Observe conductor polarity (+ and -) and also remove
the jumper on terminals 40 and 41 (if present) on the
boiler's electronic board.
Note: Refer to the electrical connections in the boiler's in-
struction handbook.
To connect to the boiler use two wires (Fig. 5) with a
minimum section of 0.50 mm
no longer than 50 metres.
Note: to ensure correct installation use a line dedicated for
connection to the Super CAR in accordance with current
laws on electrical installations. If this is not possible, probable
interference due to other electrical cables could cause the Super
CAR to malfunction.
4) Fix the body of the Super CAR to the support template,
pressing it into place (Fig. 1).
5) After you have powered the boiler wait about 30 seconds
before making the adjustments so communication between
the Super CAR and the boiler can stabilise.
, maximum 1.5 mm and
2 2
7