Resetting Errors; Resetting The Super Car - Immergas SUPER CAR Instruction And Warning Book

Code
Error in reading room temperature or value
ERR>TP
measured off scale (below 0°C or above 50°C)
Error in reading relative humidity or value
ERR>RH
measured off scale
Error in reading atmospheric pressure (relative
ERR>PS
value) or value measured off scale
Adjustment algorithm value parameters un-
ERR>LH suitable for the heating conditions requested.
Insufficient central heating capacity.
9.2

Resetting errors.

In the case of a boiler shutdown that can be reset, the
flashes. In this case by pressing the
holding it down for 5 seconds you can send a release signal
to the boiler that starts the boiler working again normally in
just a few seconds, if normal operating conditions have been
restored, it returns to working in the mode set previously.
You have up to a maximum of 5 consecutive attempts at re-
setting after which you have to wait an hour to have another
5 attempts.
22
Description
push button and
9.3

Resetting the Super CAR.

By means of the general resetting hole (fig. 7 page 8) it is pos-
sible to reset the Super CAR hardware without losing your
settings (the hour, date and hourly programme).
If you want to restore the original factory settings, use the reset
hole and press the
the Super CAR will be reset with all factory data.
icon
push button. When you release it