Programming Working Hours - Immergas SUPER CAR Instruction And Warning Book

7.2

Programming working hours.

You enter the programming window by pressing the
push button.
By following the steps described below you will be able to
create or modify the hourly programme.
1) Select the day or group of days by turning the parameter
selector:
- Monday, Tuesday, Wednesday... Sunday (single day)
- Mo - Fr (from Monday to Friday)
- Sa - Su (from Saturday to Sunday)
- Mo - Sa (from Monday to Saturday)
- Mo - Su (from Monday to Sunday)
Note. When working automatically (
bar appears on the display and indicates the different
hour phases with Comfort or Reduced temperature
for the Comfort mode.
2) Set the working hours with the comfort and reduced
temperature. Up to a maximum of 4 Comfort temperature
periods can be set within the 24 hours, each one with its
turning on and turning off time.
If you are only going to use 3 of these time periods set the
fourth with 24.00 as its turning on and off time.
20
) the 24-hour
the hyphen on the hour bar stands
Once you have selected the day or group of days by pressing
the selector, set the first working period with the comfort
temperature (ON 1) indicated by the word "ON" at the top
right and "Phase 1" at the bottom; by turning the selector you
select the first ignition time (corresponding to the time flash-
ing at the top left), pressing the selector to store it. You now
go to the next working period with the reduced temperature
(OFF 1) indicated by "OFF" at the top right and, as always,
"PHASE 1" at the bottom. Once the first Phase (PHASE 1)
is set you go automatically to the next comfort and reduced
temperature working phases. To programme them, you have
to repeat the steps described previously up to phase 4.
The sequence of the ON and OFF states must always be
sequential; it is not possible, for instance, to set "OFF 2" at
13.30 and "ON 3" at 11.00.
Once you have programmed the day or group of days, the
procedure is exactly the same for the other days.