Removableovendoor; How To Care For Yourrange - GE JB390G Use And Care Manual

How
to
care
for
Your Range
Proper care and cleaning are
important so your range will give
you efficient and satisfactory
service. Follow these directions
carefully in caring for your range
Oven WentDuct
Your range is vented through a duct
located under the right rear Calrod@
unit. Clean the duct often.
to assure safe and-proper
maintenance.
Finishes
The porcelain enamel finish is
sturdy but breakable if misused.
This finish is acid resistant.
However, any acid foods spilled
(such as fruit juices, tomato or
vinegar) should not be permitted
to remain on the finish.
The area under the range can be
reached easily for cleaning by
removing the bottom dmwer. To
remove, pull drawer out all the way,
tilt up the front and remove it. To
replace. insert glides at back of
drtiwer beyond stop on mrige
glides. Lift d~~wer if necessary to
insert easi]y. Let front of drdwer
down, then push into close.
Removable Oven I)oor
\. \
-~\=lE=
w ~ f=====
5.
~,
- _.
.
\l F==-=-
NIT=-=J
—.
\, ---
To remove door, open to BROIL
position, or where you feel hinge
catch slightly. Grasp door at sides;
lift door up and away from hinges.
To replace, grasp door at sides.
Line up door with hinges and push
door firmly into place.
,
To
remove:
Make sure unit is cool.
Lift up right rear surface unit.
Remove drip pan.
. Lifi out oven vent duct.
To replace:
Place the oven vent duct over the
oven vent located below the
cooktop with opening of the duct
under the round opening in the drip
pan. It is important that the duct is
in the correct position so moisture
and vapors from the oven can be
released during oven use. NUI"E:
Never cover the hole in the oven
vent duct with aluminum foil or
any other material. This prevents
the oven vent from working properly
during any cooking cycle.
Oven Lamp
5
CAUTION: Before replacing your
oven bulb, disconnect the electrical
power for your range at the main
fuse or circuit breaker panel or pull
plug. Be sure to let the lamp cover
and bulb cool completely before
removing or replacing.
\
To
remove:
Remove the 3 slotted screws in
the lamp cover as shown in diagram.
s Detach lamp cover and remove
bulb.
To replace:
. Put in a new 40-watt appliance ....
bulb.
-:Z'
Install lamp cover. Replace 3
screws and tighten, making sure
cover fits flush with oven wall.
Reconnect electrical power to
the range.