Default Factory Settings; How To Set Up And Test Basic Wireless Connectivity - NETGEAR WPNT834 Reference Manual

Reference Manual for the RangeMax 240 Wireless Router WPNT834

Default Factory Settings

When you first receive your WPNT834, the default factory settings are in effect, as shown below.
You can restore these defaults with the Factory Default Restore button on the rear panel. After you
install the WPNT834 router, use the procedures below to customize any of the settings to better
meet your networking needs.
Wireless Access List (MAC Filtering)

How to Set Up and Test Basic Wireless Connectivity

Note: If you use a wireless computer to configure WPA settings, you will be disconnected
when you click Apply. Reconfigure your wireless adapter to match the new
settings or access the wireless router from a wired computer to make any further
changes.
Follow the instructions below to set up and test basic wireless connectivity. Once you have
established basic wireless connectivity, you can enable security settings appropriate to your needs.
1. Log in to the WPNT834 firewall at its default LAN address of
http://192.168.1.1) with its default user name of admin and default password of password, or
using whatever LAN address and password you have set up.
4-8
FEATURE
Wireless Router Radio
SSID broadcast
SSID
802.11b/g RF Channel
Mode
Authentication Type
WEP
DHCP Server
DHCP range
v1.0, November 2005
DEFAULT FACTORY SETTINGS
Enabled
All wireless stations allowed
Enabled
NETGEAR
11
Auto 108
Automatic
Disabled
Enabled
192.168.1.2 to 192.168.1.254
http://www.routerlogin.net (or
Wireless Configuration